![]() |
| Toilets with Shelves |
Make marks 3 inches on each side of the midpoints. A longitudinal center line drawn Through the mark in each table, perpendicular to the ends. Mark the lines 3 inches from the ends of the boards. Draw to connect brands to form a the end of each table. Use a jigsaw to cut the V-shaped grooves
Place the plates cut on a flat surface, side by side, with the notches in the same direction. Align the ends of the table. Measure from the lower end of a notch plate to mark Where the lower platform fitted. The bottom shelf Should be approximately 2 inches above the top of the toilet cistern. Use a framing square to draw a line Through Both tables. You Decide Where You will place the two shelves Between the upper and lower shelves. Draw a line-through aligned Both boards In These positions.
Applying glue to one side of each supporting rail. Center support rails at joints notched so that the upper edge of each support rail is aligned with the lower edge of the shelf positioning lines. Place a weight on each rail to prevent the rail from moving as the glue dries. Allow the glue to dry completely according to the manufacturer's instructions.
Draw a line down the center of the support rails end to end. Use countersink drill bit for drilling pilot holes evenly spaced across the lines, approximately 2 inches apart. Place the support rail joints with drywall screws and a drill and driver bit. Fill countersunk holes with wood putty.
More info or low price with quality :
https://decorsus.com/shop-by-category/bathroom-vanities


No comments:
Post a Comment